#63607 Craftsman motor just buzzes

I'm sorry I can't help myself. But I would expect to find some ideas at the website

Or, is there a component in the starter circuit that would

I know it's a different animal, but when the arbor bearings on my 113.x Table Saw went bad I could feel the blade jerk when turning it by hand. However, the saw did start on its own and appeared to run fine. Try turning the blade by hand to see how smooth it is.

Once in a very great while, it would hum and not start. A retry or a sharp whack on the motor with a mallet would start it. It hasn't done that in more years than I can remember.

Try blowing the dust out again. Maybe you moved something to a spot that's causing a bad connection. It can't hurt.

My WAG is a bad start relay.

Emerson has no listings for replacement motors for that model.

Bad switch contacts? That would keep the start capacitor disconnected from the circuit and prevent a clean start.

Probably it, but my table saw motor is from the early 50's. When it did this 45 years ago, thinking I don't know jack about electric motors, I took it to a motor repair shop and for $100 they fixed it. Few years later it did it again, so I took the motor apart and sawdust was clogging the switch area. Cleaned it out and worked good as new. The motor had/has opened vents that lets in sawdust by the pound. I put a nylon stocking over the ports and it took 35 years for it to happen again, and I fixed it the same way, and it still works like new.

Hopefully his motor is totally enclosed, unlike mine, and it's just the switch. I fixed a lot of old washing machine switches just by cleaning/tinkering with the switch. _- Jack Tolerance is the virtue of the man without convictions.

I think your clutch friction material is glazed and not transmitting rotation properly. Try lightly sanding the clutch friction material with a very fine sandpaper just to remove the glaze on the friction material (return material to near original friction coefficient). You don't need to sand much so as not to remove material. This allows the clutch to work properly again, and hopefully, not slip.

If it is a capacitor start motor, if you clean the contacts in the the little box at the top of the motor that may correct the problem.

The motor on my table saw start doing that and would not turn over. I took it to a shop. He disassembled it, showed my what the problem was cleaned, and blew out the area and it has worked perfectly for the last