i'm trying to fit a washing machine hose so it doesnt leak. initially it was because one washer was missing on the straight end (connects to cold water supply).
i've got a washer now 3/4" same size as on the other end. but it doesnt seem to be obvious how to fit it. the plastic part is different on the end that goes into the machine. there is more of a lip for the washer to sit on securely. can anyone tell me how it should be fitted or send a photo or something??
Just installed a new dishwasher ...
The two ends were different, one end takes a standard looking rubber washer the other takes a rubber washer with a large integral metal sieve (particulate filter) which extends 3-4 mm into the connector it mates with.
Not seen one like this before. Note that the old pipe that came off with the old dishwasher wasn't like that it was symmetrical. So clearly they vary.
Maybe try a new pipe set complete (from B&Q) ?
Derek
thanks i'll have to check again in a DIY store. i went down there and looked the other day but i think i was looking at the wrong end. i'm pretty sure each end has a different type of washer as the 3/4 inch one doesnt want to fit comfortably on the inlet pipe end!
Have something to add? Share your thoughts — no account required.
Ask the community — no account required