Squirty foam in difficult places

Andrew Mawson · 2009-06-19T13:46:10+00:00

I need to foam seal the join between the top of a wall and somecorrugated cement fibre sheeting - access is only from inside and itis at the top of the slope, (ie the roof / wall angle is less than 90degrees). I have a foam gun and foam, but the canister has to pointupwards and there IS no upwards space! Tilting the canister sidewaysonly allows a small part of the can volume to be used and I've 40 footto do.I've tried pushing an extension tube onto the gun, but with theshortest length able to gain access the foam barely makes it out ofthe end of the 1/2" tube - any suggestions???????????????????????AWEM

Jun 19, 2009 20 Replies

Rate this thread:

Tim S 17 years ago

snipped-for-privacy@sheldononline.co.uk coughed up some electrons that declared:

I'm migrating to TS due to prices... I'll try that.

Cool - I'll give it a go - ta.

Cheers

Tim

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required

Squirty foam in difficult places

Related discussions

Further on expanding foam guns

How to drill a hole in a noggin half way down a stud partition wall?

oh sh..! foam gun died

Join the Discussion

Didn't find your answer?