Fitting kitchen corner unit

In message , mjbarnard writes

More or less. Usually there's some dimension info in the assembly instructions or there are pre-drilled dowel/screw holes to fit the corner post.

Yeah, that 3cm gap is where all the contents pushed into the dim and distant recesses of the "corner" cupboard disappear! I normally close off the "hidden" open face (IYSWIM) with a sheet of MFC - generally you've got a few carcass end panels spare from where "decor" ends have been fitted. Add a bit of packing up to the depth of the corner post and you've then got something rigid to screw / bolt through to the adjoining cupboard. YMMV.

You probably won't be able to open the drawers/doors if you loose the corner post gap. It is necessary.

Are you making a U-shaped kitchen, with 2 corners? if so, you can save a bit on the width by chopping a couple of cms off the back of the units making up the two sides of the U. In other words make them a bit less than the standard 600mm depth. This assumes your units have a 100mm or so dead space behind the backboard of the cupboards.

Phil The uk.d-i-y FAQ is at