Bought some Bulgin Buccaneer IP68 rated connectors. The chassis mount one has a rubber gasket between it and the chassis and is secured by four screws. There are four 'top hat' bushes supplied also with the same hole size as both the fitting and gasket - but no information on how they're used. Looked at the PDF on the Rapid site - no clue there. They're not even shown. Any guesses?
Bulgin Bucanner
Oct 22, 2009
3 Replies
Are they for specially thin or thick panels?
Owain
=A0 London SW
Bulgins own PDF refers to them as Screw sealing grommets, guess to seal under screwhead stop wicking through panel.
formatting link
locking rings dont survive being dropped very far...
Cheers Adam
the panel mount specific one. But they don't appear to fit in the flange holes so I'm slightly confused about how to fit them?
Oh dear. Hopefully it will get light and careful use.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required