Power Tools

need wiring diagram for 240volts on pressure switch on air compressor

No further details provided

0 comments posted 12yrs

posted by Anonymous

0 comments posted 12yrs posted by Anonymous

my B & D circular saw runs fine till I apply it to wood. The blade stops. Ideas?

No further details provided

1 comments posted 12yrs

posted by Anonymous

1 comments posted 12yrs posted by Anonymous

speed control for band saw

want to slow band saw down while cutting steel

0 comments posted 12yrs

posted by Anonymous

0 comments posted 12yrs posted by Anonymous

My bosch bulldog hammer drill quit hammering

I was chipping concrete and then there was a pop and it just stopped working

1 comments posted 12yrs

posted by Anonymous

1 comments posted 12yrs posted by Anonymous

I have a poulan chain saw. Its starts and runs great sometimes and then sometime it pull hard .

No further details provided

0 comments posted 12yrs

posted by Anonymous

0 comments posted 12yrs posted by Anonymous

how to raise and lower router bit on model 315.25070

No further details provided

0 comments posted 12yrs

posted by Anonymous

0 comments posted 12yrs posted by Anonymous

Need recommendation for a wide-crown stapler for use on treated wood.

I am interested in a 1"w x 1"L and 1"w" x .75"L staples (preferably stainless steel but galvanized if prudent) for outd...

0 comments posted 12yrs

posted by Don...A relative novice

0 comments posted 12yrs posted by Don...A relative novice

Delta 36-320c

I have a Delta 36-320c that keeps throwing the belt. Is there anyone who knows how to remedy this ?

0 comments posted 12yrs

posted by tony

0 comments posted 12yrs posted by tony

How do I remove chuck from delta 11-100 drill press?

How do I remove chuck from delta 11-100 drill press?

0 comments posted 13yrs

posted by Anonymous

0 comments posted 13yrs posted by Anonymous

what ratio of gas/oil do I use in a Trim-rite Edger model TR515K with a TC II (Tecumseh) 1.5 Hp

No further details provided

1 comments posted 13yrs

posted by Anonymous

1 comments posted 13yrs posted by Anonymous

parts for a drill press

i have a oit drill press i am tring to fine the table ajust that lets you move the table up&DOWN -AND THE angal of the...

0 comments posted 13yrs

posted by allen a todd

0 comments posted 13yrs posted by allen a todd

lubricant for a worm drive saw

Hello.I have a 1952 Vintage Cummins 6" circular saw with worm drive.Any one have an idea what kind of lubricant would b...

0 comments posted 13yrs

posted by thewidowmaker

0 comments posted 13yrs posted by thewidowmaker

has anyone ever used a Paslode 16 ga. angle nailer to install flooring?

I was looking for info on installing some 3/8 inch bamboo flooring from liquid liquidators. Sure they have the tools to...

0 comments posted 13yrs

posted by erice2000

0 comments posted 13yrs posted by erice2000

where can I find the motor used on the craftsman radial saw model 11349771

No further details provided

0 comments posted 13yrs

posted by dirty_harry00

0 comments posted 13yrs posted by dirty_harry00

I wish to put a Indicator low voltage lite off a 12 volt charger

I have a 12 volt battery charger coming off a transfer switch that is charging a starting battery. I would like to put...

0 comments posted 13yrs

posted by Randy

0 comments posted 13yrs posted by Randy