Painting inside microwave oven

I'd be inclined to some of the epoxy paints, due to wear considerations. I bought some stuff from Brownells a while ago, called "Alumihyde," which is an epoxy paint for firearms. Comes in colors. I've used it for other stuff, such as painting tools, tool handles, etc., where I want a really tough finish.

I would expect that Lowes or Home Depot might have something similar.

snipped-for-privacy@myplace.com wrote in news: snipped-for-privacy@4ax.com:

The epoxy suggestion sounds good. Maybe some porcelain paint used for appliances/sinks if you have some around.

deadgoose wrote the following:

They are two part finishes like the epoxy cements, right? I worked in a building that was repainted with two part epoxy paint. They had to mix the two parts before applying it with brushes.

Somewhere I picked up a small bottle of the stuff for "patching." Tough, and useful for all sorts of things.

Just line it with aluminum foil. You will never have to clean it again.

Steve

In practice, any white enamel will work fine, but if you want to be completely proper, use microwave oven cavity paint, sold for painting the metal duct that goes between the magnatron tube and the interior (mica cover over it -- lets in microwaves but keeps steam and food fumes from building up in the cavity and on the magnatron):

You may be able to get away with just treating the rusty spots with phosphoric acid rust remover (Naval Jelly), but don't leave it on too long or it will damage the paint. Phosphating the metal also makes the new paint stick better.

NO! Aluminum foil can cause arcing and even result in a fire.

Like I said ....................

Yes, but it is beautiful. Microwave a CD for five seconds. It gives you a neat looking cd, too.

Steve

Why is it that you can soften the frozen juices that come in the cardboard cans with the metal ring on the bottom?

I've been doing for years...my old Sharp manual even suggested it.

It never arcs.

Whoooosh

I got a defective microwave oven from General Electric. It was never abused, but the paint inside the cavity peeled badly. It was out of warranty so of course I was out of luck.

I bought high heat paint for barbecue grills (I chose the almond color) and after a good sand and scrape I painted the microwave interior.

It has been almost a year, and the grill paint is holding up well.

It depends on how close it gets to something else that is metalized. It has to arc to something.

Yes, that's why the comment, "You'll never have to paint it again."

WHOOOSH .......... the sound of a projectile passing over empty air space ...........

Steve

Darken the room. Put a CD in with the top down. Set it for five seconds. They sparkle a lot, too.

Steve

In Californianstan there was a company, Deposition Technologies that made metalized plastic films like the square piece of metalized plastic in the bottom of microwave popcorn bags. The purpose is to make a hot spot so the corn will pop. I'm not sure what became of the company, it was probably bought out or merged with another but I did some work there in 1989 on the installation of a glue machine that applied glue to the polymer films they produced. I later came to believe that the machine I worked on was used to make the radar absorbing film for the B2 bomber skin. I wish I could find out what happened to the company, I'm curious.

TDD

replying to jw, Don Williams wrote: Yes u need a special paint. It is called " microwave cavity paint " it is for inside of microwave. Wal-Mart sells it online only. Go online for other places.

replying to jw, Bob wrote: What kind of spray paint do I need for the question above

replying to Steve B, The Good Nurse wrote: Steve, I know your posts are old, but come on! You're saying idiotic things that will potentially cause fire or great harm. What's your problem? 's