I have a 5000 Gallon Tank that I have a 1 1/2" supply that will be feeding a
house with a 1 1/2" line.
The house could have 3 showers, Dishwasher and Laundry all going at the same
time. What size booster pump should I be looking at? I was thinking a 1HP
Then what is the best way to connect the booster pump to the PVC? I was
hoping to get some sort of Flex piping similar to the stuff that is
connecting the Pool equipment. Help cut back on the vibration to the rigid
conduit and to the structure. Though have not found much in the Flex 1 1/2"
connections. Any Suggestions would be helpful.
<delete cross-post to you-know-who>
I just want to ask if there will be some sort of
accumulator (bladder tank) at the house end of
I don't think you can run the pump without one
or perhaps with a pressure bypass around the pump.
So how do I determine my GPM?
I figure 3 showers @ 2 GPM, and the Dish and Close washer at maybe 1 GPM, so
that would be 8GPM, so make it an Even 10 GPM, Pressure we would like
between 40 and 70 PSI . I think we are between 30 and 60 now and its a bit
Hmmm... have not thought of the Flex Cracking. It will be all Indoors and
out of any Sunlight.
wrote in message
The flow sounds about right for showers, but the washer is probably more,
maybe 10 gallons itself. I don't know the capacity of the typical machine,
but I think they use 15 to 20 gallons per cycle so you can time how long it
takes to fill . "Normal" pressure is about 50 psi but 80 to 100 is not our
of the question. If you have the right piping, that should carry the load.
It is probably overkill to gear up to supply every water using appliance in
the house at the same time. If three people are taking showers, just shut
the clothes washer off for a few minutes and save a lot of aggravation and
potential temperature fluctuations.
What is going to turn the pump off and on? Is it going to be set up with a
pressure tank between the pump and point of use?
We have a Front Load washer, and I think it uses 2.5 gallons per cycle(Wash,
So we make it 15 GPM to be on the safe Side?
To add a Wrinkle The reason for having 3 Showers and Laundry going at the
same time is because I'm actually feeding 2 Houses. So there could be a
potential there that it could happen. Anyway...
So I'll have a Pressure sensor that is hooked up to my control Panel, and
the Control panel will Control the Pump.
Here is a Diagram of the Plumbing:
HomeOwnersHub.com is a website for homeowners and building and maintenance pros. It is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.