Briggs & Straton 16hp Vanguard governor spring routing

Oct 01, 2005 2 Replies
D

Does anyone have a picture of where the governor and throtle sprin



hook? I did an overhaul and can't figure out where they go. I think I hav all but one right, but I get a slight speed hunt. The Model # is 303447 and the code # is 0378. The motor is on a 10000 watt generator with the controled speed. I have looked in books and talked to the local dealer with no help. I wish I would have taken a picture before hand.



Thanks for any help, Dav


-- djacob



----------------------------------------------------------------------- djacobs's Profile:

formatting link
this thread:
formatting link


Vote
Twitter Facebook LinkedIn
D

i cant answer your question,but i do know there is procedure to set or calibrate the governor linkage so it doesnt hunt. you hold the gov arm so its against the gov gear and throttle wide open then lock in that position. i have been taking films of engines befor i tear them down with a cam corder.it helps me alot.lucas

formatting link

Vote
Twitter Facebook LinkedIn
D

Thanks for the Info.

I have one spring left and don't know where it goes, wish I would hav taken a few pictures. dav

-- djacob

----------------------------------------------------------------------- djacobs's Profile:

formatting link
this thread:
formatting link

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required