Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

tormek good or bad

Folks, No this is not another attempt to stir the pot. Basically, I need to keep kitchen knives sharp. I have tried the...
23 comments posted 19yrs
posted by pbishop
23 comments posted 19yrs posted by pbishop

1 1/4" Oak Closet Rod Dowel Over 4 ft.?

I am in the middle of a home improvement (?) project. It am going to replace the existing dark walnut stained pine clow...
10 comments posted 19yrs
posted by None
10 comments posted 19yrs posted by None

Extreme Doghouse Contest

http://www.skiltools.com/en/UseYourSkil/ExtremeDoghouseContest/ I say, let 'em make their own damned doghouse. JOAT "I'...
0 comments posted 19yrs
posted by Jakofalltrades
0 comments posted 19yrs posted by Jakofalltrades

Need to stain cherry to dark cherry

I made some shelves to go over a window in my bedroom out of cherry. I applied some shellac to a piece of scrap and it'...
25 comments posted 19yrs
posted by craigtoth
25 comments posted 19yrs posted by craigtoth

Which wood for making smoking pipes?

I thought briar wood is the wood of choice for making smoking pipes. I have not seen this wood available anywhere. Is t...
9 comments posted 19yrs
posted by noone
9 comments posted 19yrs posted by noone

Tapering Legs (TS or BS?)

When performing leg tapers, which do you prefer? I think I prefer to do these at the TS, but on my last project I made...
10 comments posted 19yrs
posted by .
10 comments posted 19yrs posted by .

Looking for end/coffee table legs...

I'm looking for some end/ coffee table legs similiar to these at Rockler's, but, a bit less expensive. I need 8 in the...
3 comments posted 19yrs
posted by ronaldjangel
3 comments posted 19yrs posted by ronaldjangel

Where are furniture binaries

Haven't visited here in a year (since Forte Agent insisted on payment). Is there still a binaries group? I only found a....
2 comments posted 19yrs
posted by bmchan
2 comments posted 19yrs posted by bmchan

Best Woodworking Magazine

I got my renewal notice for FWW, just after getting that horrible issue with the article on clamping - yea, one of thos...
19 comments posted 19yrs
posted by eclipsme
19 comments posted 19yrs posted by eclipsme

how to fill an irregular hole?

Hi, folks, I'm doing some trim work on my old house and I have discovered a big ol' HOLE in a wooden panel. I'm guessin...
12 comments posted 19yrs
posted by largecorp
12 comments posted 19yrs posted by largecorp

Kity Speed Supplier

I have a partial can of Kity Speed N 2973. Apparently made by or sold by Kity, made in W.Germany. Directions in French...
3 comments posted 19yrs
posted by grover
3 comments posted 19yrs posted by grover

OSB And Hardwood Floors

I have a situation in a 13yo townhouse (I own this one) where the first floor has about 325 sq ft of 1/2" hardwood lami...
6 comments posted 19yrs
posted by tundra
6 comments posted 19yrs posted by tundra

Particle Board Woes

I find that after I visit big stores that have lots of dusty particle board, plywood and MDF stacked around that I have...
15 comments posted 19yrs
posted by Bill_NOSPAM
15 comments posted 19yrs posted by Bill_NOSPAM