Woodworking Forum

  1. Home
  2. Woodworking Forum
51625 Threads Posts
to

Worth reading in Woodworking Forum

Source for *magnetic* extended drill drivers

For hard to reach places where your hand may not fit into to hold the screw on the tip of the driver. 6" to 12" would b...
17 comments posted 14yrs
posted by John
17 comments posted 14yrs posted by John

Finishing Cabinets ?

I have been experimenting with getting a "cherry" finish on hard maple. I have been going water-based all the way, usin...
4 comments posted 14yrs
posted by RimaNeas
4 comments posted 14yrs posted by RimaNeas

Robin Hartl

Flipping through channels the other night and saw Robin harking the Giant Ladder system. Something that she's been doin...
16 comments posted 14yrs
posted by mjmwallace
16 comments posted 14yrs posted by mjmwallace

OT: Work pants

So I'm a big fan of Carhartt double knee work pants, but even though they are double knee, I still tend to wear through...
3 comments posted 14yrs
posted by mwskaneateles
3 comments posted 14yrs posted by mwskaneateles

Band Saw Blade Recomendations

I need band saw blades and would like some recommendations. I have 10" low-end saw that takes 72 5/8" blades. I'm looki...
8 comments posted 14yrs
posted by teamarrows
8 comments posted 14yrs posted by teamarrows

What is it? Set 418

Another set has been posted to the web site: http://55tools.blogspot.com/Rob
28 comments posted 14yrs
posted by rhvp65
28 comments posted 14yrs posted by rhvp65

Best source of free (old) ww e-books I've seen

http://www.craftsmanspace.com/free-books/woodworking-joinery-tehniques-hand-tools.htmlIf you don't mind books that are...
22 comments posted 14yrs
posted by Bill
22 comments posted 14yrs posted by Bill

Router table recommendations

I have only recentlydiscovered router tables but wasn't sure I really needed one. So I picked up an inexpensive Ryobi a...
27 comments posted 14yrs
posted by ralphcompton
27 comments posted 14yrs posted by ralphcompton

Does anybody have a good recipe for board butter?

I recently tried to make a batch of board butter to apply to some cutting boards. I used 16 fl oz of mineral oil, 4 or...
0 comments posted 14yrs
posted by monkeyman
0 comments posted 14yrs posted by monkeyman

Earlex 6900 HVLP Review

Tried my 6900 today on a customer's kitchen remodel. Sprayed Zinsser Bin Primer on 28 new cabinet doors, 10 new drawer...
0 comments posted 14yrs
posted by rich
0 comments posted 14yrs posted by rich

Butcher block countertop

Do you dare make a butcher block countertop out of edge grain 3/4 or 1" wide boards? It looks like 2 x material is more...
0 comments posted 14yrs
posted by mikerbgr
0 comments posted 14yrs posted by mikerbgr

O/T: Outhouse

Enjoy Lew ------------------------------------- Some of you young 'ens may not understand this one...... Ma was in the...
0 comments posted 14yrs
posted by sails.man1
0 comments posted 14yrs posted by sails.man1

Gluing plywood back of cabinet...

Is there any problem with gluing 1/4" birch plywood back to the 3/4" birch plywood frame? i.e., can I assume that plywoo...
4 comments posted 14yrs
posted by NOSPAM
4 comments posted 14yrs posted by NOSPAM