Woodworking Forum

51629 Threads Posts
to

Letter Templates

Hi All , I know that Rockler has a set of templates with letters and numbers of a couple different sizes .Is there anyo...
2 comments posted 22yrs
posted by brc4
2 comments posted 22yrs posted by brc4

sharpening router bits

I have a freud 3/4" double flute router bit that I seem to have worn out. Cost is < $20 to replace -- any reason to thi...
13 comments posted 22yrs
posted by ehagemann
13 comments posted 22yrs posted by ehagemann

Felder

I had the opportunity to use a Felder the other day. perfection is a hard thing to describe but Felder may sum it up. R...
4 comments posted 22yrs
posted by gmmillen
4 comments posted 22yrs posted by gmmillen

have bedrock 602 and need advise

Hello, I would like to get some advise and if possible an appraisal of this plane or for someone to steer me to an indi...
2 comments posted 22yrs
posted by chris
2 comments posted 22yrs posted by chris

walnut lumber in Richmond

Has anyone dealt with these folks for lumber, specifically walnut? http://www.hardwoodgroup.com/richmond/index.htmI jus...
8 comments posted 22yrs
posted by eyancey
8 comments posted 22yrs posted by eyancey

Jesada Update???

I am getting ready to purchase some more router bits. In the past Jesada was my default choice but last fall I had some...
11 comments posted 22yrs
posted by bobmcbXXX
11 comments posted 22yrs posted by bobmcbXXX

Grades of stainless steel fasteners?

McMaster-Carr sells three different grades of stainless steel fasteners. I know 316 is expensive because it is most cor...
11 comments posted 22yrs
posted by belfert
11 comments posted 22yrs posted by belfert

Why Thin Pins

I've always heard that dovwtail joints with very thin pins are a mark of craftsmanship. I can understand that in that i...
30 comments posted 22yrs
posted by n5kzw
30 comments posted 22yrs posted by n5kzw

TurboCAD

I have TurboCAD 3.01. I've spent time with the manual, and find it confusing. I've spent time with the built-in tutoria...
3 comments posted 22yrs
posted by nekias
3 comments posted 22yrs posted by nekias

Besimer fence on a powermatic saw?

I have a quick question - I have a Besmier fence on my delta cabinet saw. Im looking at picking up a old 5hp powermatic...
8 comments posted 22yrs
posted by rob
8 comments posted 22yrs posted by rob

New sole for an old plane

I've got this old wood-bodied Sargent plane (22") that I'm trying to tune up. I ran the sole over a jointer to clean it...
2 comments posted 22yrs
posted by slach
2 comments posted 22yrs posted by slach

Q: Cabinet saw and router table wing

I'm interested in purchasing the Grizzly 1023 cabinet table saw (moving up from a benchtop unit), and wonder if anyone...
0 comments posted 22yrs
posted by rocknice123
0 comments posted 22yrs posted by rocknice123