Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Electric Winches for sale.

Check our Superwinch's electric winches for sale at www.guy-stuff.com/superwinch.htm. Thanks!
1 comments posted 21yrs
posted by bradsmith1965
1 comments posted 21yrs posted by bradsmith1965

Looking for FWW article

I vaguely remember an article in FWW within the past year or two about finishing birds eye. Can anyone point me to which...
4 comments posted 21yrs
posted by stevec1280
4 comments posted 21yrs posted by stevec1280

Safety Chain

I would like to install safety chains to steel doors. 2 screws go into the door frame which is fine, however the other...
0 comments posted 21yrs
posted by rreiniger
0 comments posted 21yrs posted by rreiniger

Unisaw for Christmas

My wife thought I was good this year and bought me the Unisaw that I wanted for Christmas (Kwanza, Birthday, anniversar...
4 comments posted 21yrs
posted by bob
4 comments posted 21yrs posted by bob

New SIG Delta 36-560 table saw

Hello all; I have started a new SIG group for owners of the Delta 36-560 table saw. If you own one or are interested in...
0 comments posted 21yrs
posted by kc5gxl32
0 comments posted 21yrs posted by kc5gxl32

small gloat + name that wood

Over the holidays I attended a funeral for a distant relative, afterward another relative gave me 3 different woods tak...
3 comments posted 21yrs
posted by of_the_rose
3 comments posted 21yrs posted by of_the_rose

source for thin lumber

Folks - I am looking for thin lumber sources. I need 1/2" KD stock and due to the volume, I think I may be better off i...
0 comments posted 21yrs
posted by johnmoorhead
0 comments posted 21yrs posted by johnmoorhead

Ridgid ROS 2600 and 2610

I know this has been discussed before, but some quick searches came up empty. Sorry. Pt me to them if you wish. What ar...
8 comments posted 21yrs
posted by nospam_coloradotrout
8 comments posted 21yrs posted by nospam_coloradotrout

Re-sawing:

Hello all . I was thinking of getting an band saw for an special project but not sure of its capabilities. I would like...
7 comments posted 21yrs
posted by sjimk
7 comments posted 21yrs posted by sjimk

buying advice wanted: set of brad point bits

I want a good set, minimal runout, of brad point bits. I have the cheapo HF set, but the runout is horrible. I probably...
5 comments posted 21yrs
posted by nospam_coloradotrout
5 comments posted 21yrs posted by nospam_coloradotrout

buying help needed: wood/metal drill bits

I want a good set, minimal runout, of 1/16th to 1/4 inch drill bits for both metal and wood. I have some old sets that a...
2 comments posted 21yrs
posted by nospam_coloradotrout
2 comments posted 21yrs posted by nospam_coloradotrout

Polish question

I have an old table which I cleaned with Murphy's Oil Soap. It did a pretty good job of cleaning it but now the finish...
5 comments posted 21yrs
posted by seagle
5 comments posted 21yrs posted by seagle

Omnijig through dovetail help needed

I cut my first through dovetails today, and have someproblems. 1) They are a bit tight on the inside and required a ham...
2 comments posted 21yrs
posted by toller
2 comments posted 21yrs posted by toller