Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

12" Planer Deal at Orange Borg?

I'm just about to purchase a planer. I was going to get the RIDGID 13", but they just put the Delta TP300 on for $199 (...
4 comments posted 21yrs
posted by mrcomp
4 comments posted 21yrs posted by mrcomp

Pretty Cherry Clock...

Some things only get better with age, cherry is one of those things. I made this clock about a year and a half ago for...
4 comments posted 21yrs
posted by dfeisan
4 comments posted 21yrs posted by dfeisan

Accurate cursors, elinating parallax errors

I just read another magazine article complaining about the error induced if you don't look straight down on a cursor th...
15 comments posted 21yrs
posted by pinkflash123
15 comments posted 21yrs posted by pinkflash123

Picture Frame Mitres - Saw or Guillotine?

Guillotine or Manual Mitre Saw? The guillotine is quicker. The mitre saw may need finishing with a 45 degree bench sand...
7 comments posted 21yrs
posted by fastrack1966
7 comments posted 21yrs posted by fastrack1966

re: cheap black walnut in NJ

Google wasn't allowing me to post a followup to the original thread (too old I think) so I'm posting the followup under...
1 comments posted 21yrs
posted by sw
1 comments posted 21yrs posted by sw

looking for tips re crown moulding install

Hello, I have some crown moulding I'm about to install as part of a kitchen remodel/cabinet installation. This is the f...
2 comments posted 21yrs
posted by kzinNOSPAM99
2 comments posted 21yrs posted by kzinNOSPAM99

Solid wood biscuits??

Ran a test with #10 biscuits on a right angle butt joint. End grain to long grain. Two biscuits in the joint. 24 hours...
27 comments posted 21yrs
posted by ricksub
27 comments posted 21yrs posted by ricksub

What can I do with this hickory?

I've got 20 2' logs of healthy hickory that my neighbor cut down. I normally would season it and burn it for firewood, b...
15 comments posted 21yrs
posted by deanbrown3d
15 comments posted 21yrs posted by deanbrown3d

A vastly underrated wood?

Hello all, When I went to the local hardwood supplier this week to get a piece of butternut for my wife to use with her...
32 comments posted 21yrs
posted by noneofyer
32 comments posted 21yrs posted by noneofyer

Router Speed for Raised Panels

I am fixing to make some raised panels out of MDF and Oak, What router speed does anyone recommend. I am using a vertic...
1 comments posted 21yrs
posted by jjjcook
1 comments posted 21yrs posted by jjjcook

Router Template Lettering

Hi Guys and gals Do you have any idea who supplies pre-designed Template Lettering. Otherwise I will have to design my o...
3 comments posted 21yrs
posted by eperreaux
3 comments posted 21yrs posted by eperreaux

Free Wood - Tucson AZ

I have a rather large stack of cherry, maple and a few odds and ends mixed in. 4/4 and 8/4. Moving and can't take it wi...
7 comments posted 21yrs
posted by jecarroll7
7 comments posted 21yrs posted by jecarroll7

Home office design and construction book

I need to do a built-in home office setup for SWMBO after her eyes popped out at a local company's quote. Any recommend...
5 comments posted 21yrs
posted by chiefneil
5 comments posted 21yrs posted by chiefneil