Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

3/4 in. Brazillian Cherry

I've been doing a lot of research on this topic and I've seen a couple different answers to this question based on the...
4 comments posted 20yrs
posted by jturner21
4 comments posted 20yrs posted by jturner21

Hardwood board end paint color significant?

DAGS and read the FAQ with no luck. Just purchased a fair amount of hardwood from an auction at a cabinet shop. It's al...
4 comments posted 20yrs
posted by mike72903
4 comments posted 20yrs posted by mike72903

Trouble with half-blind dovetails

I have used through-dovetails on a very few occasions in the past, which I cut by hand with OK results. However, I'm fa...
10 comments posted 20yrs
posted by toddrf
10 comments posted 20yrs posted by toddrf

Plans for pattern cutter jig/template

Hi, Newbie here. I've got one of those pattern making router bits that I'm going to use to redo my kitchen cabinet door...
0 comments posted 20yrs
posted by fuji01
0 comments posted 20yrs posted by fuji01

Paste Wax

Finally got the Rigid TS3650. It took 8 whole days after moving into the new house before I got enough time to go get i...
14 comments posted 20yrs
posted by lad60606NOSPAM
14 comments posted 20yrs posted by lad60606NOSPAM

Quality of Infinity router bits ? ? ?

I recently ordered a Jesada rabbet bit kit with multiple bearings. When the order arrived it was an Infinity bit. I cal...
9 comments posted 20yrs
posted by fkozerski
9 comments posted 20yrs posted by fkozerski

Grizzly G5959Z 5hp table saw

Anyone out there own this beast? I am considering it and had a couple questions. It is a 12", 5hp, 220volt single phase...
12 comments posted 20yrs
posted by fketchum
12 comments posted 20yrs posted by fketchum

Building a table using Cherry

My wife wants a end table for the bedroom and would like it to match our existing bedroom set which is cherry also. The...
5 comments posted 20yrs
posted by creekbuster
5 comments posted 20yrs posted by creekbuster

FA Cyclone separator PRICE REDUCED! Last chance

Last chance. Last auction. At this price, it's stupid to sell it but I need the room. E-Bay Item # 7569255546
1 comments posted 20yrs
posted by hamilton
1 comments posted 20yrs posted by hamilton

WalMart redux

I read a story in today's Roanoke paper that says a Tampa, FL WalMart managed to stick its footsies in the fire again....
94 comments posted 20yrs
posted by charliediy
94 comments posted 20yrs posted by charliediy

LV dust collectiong/ air criculation

Hell Everyone, Has anyone used a portable dust collector? Looking at the LV portable, size wise it's big enough for the...
2 comments posted 20yrs
posted by jgerhardt
2 comments posted 20yrs posted by jgerhardt