Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Cypress door

I'm going to make a new entrance door in order to keep the leaded glass that is in the current door. I think I would li...
4 comments posted 20yrs
posted by oak77539
4 comments posted 20yrs posted by oak77539

Cutting Board problem

I made a little simple cutting board and afterward I sanded in canola oil with 400 grit paper. However, the board is un...
8 comments posted 20yrs
posted by rob
8 comments posted 20yrs posted by rob

Router Raizer

I think this is one piece of accessory for the router that is well over the limit in price for what it is. the cheapest...
1 comments posted 20yrs
posted by allo
1 comments posted 20yrs posted by allo

Lyptus hardwood floor installation

Hi Everyone, Does anyone know an installer near Itasca, Illinois for installing Weyerhaeuser's Lyptus VanGogh Strip Ser...
0 comments posted 20yrs
posted by minmai.chu
0 comments posted 20yrs posted by minmai.chu

Wood Movement in a table

I am building a fairly large table and asked about dealing with the wood movement a few days ago. After much thought I...
8 comments posted 20yrs
posted by Toller
8 comments posted 20yrs posted by Toller

Rojek Combination Tool?

Some troll below asked about whether measurements he couldn't possibly have made were adequate, and someone else provid...
44 comments posted 20yrs
posted by Toller
44 comments posted 20yrs posted by Toller

What should I pay for a cordless circular saw?

I am interested in buying a cordless circular saw I saw on ebay ( http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&it...
31 comments posted 20yrs
posted by cindi
31 comments posted 20yrs posted by cindi

Leigh D4R - bit the bullet

I finally bit the bullet and bought a D4R. In the past, I've been hand-cutting dovetails for fine work, and using other...
10 comments posted 20yrs
posted by nospam
10 comments posted 20yrs posted by nospam

INFO - Compound Miter Chart

http://www.betterwoodworking.com/compound_miter.htmJOATYou'll never get anywhere if you believe what you "hear". What do...
0 comments posted 20yrs
posted by Jakofalltrades
0 comments posted 20yrs posted by Jakofalltrades

Advise on CAD software please, TIA

Hi all, I?ve done woodworking for a long time now as a hobby, but redundancy has pushed me into it full time now and I...
1 comments posted 20yrs
posted by noggo99
1 comments posted 20yrs posted by noggo99

History question: use of screws

We were having a discussion about woodworking and the use of nails vs. screws. Do people know when woodscrews started t...
7 comments posted 20yrs
posted by pete
7 comments posted 20yrs posted by pete