Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

garage/shop wiring question

I'm purchasing a house with an attached garage, and will be adding a subpanel for use as a shop. The garage is already...
19 comments posted 20yrs
posted by cbf123
19 comments posted 20yrs posted by cbf123

spiral scroll saw blade question

I have a Dremel Scrollsaw station and am having difficulty putting on the spiral blade (no pin). Can anyone give me any...
4 comments posted 20yrs
posted by emily345
4 comments posted 20yrs posted by emily345

aluminum poles

I have a project that would be easier with a long aluminum pole (16 feet) does any one have any idea what type of suppl...
8 comments posted 20yrs
posted by taxconsultant
8 comments posted 20yrs posted by taxconsultant

NOT a whizzing contest

Gents (and ladies, too) I have had the terribly brilliant and incredibly original idea of laying a router on its side i...
8 comments posted 20yrs
posted by replyon
8 comments posted 20yrs posted by replyon

Mortiser and Router to make a mortise?

Does anyone combo a mortiser and a router to make a mortise? I ask because, as much fun as my delta mortiser bits have...
15 comments posted 20yrs
posted by purduephotog
15 comments posted 20yrs posted by purduephotog

Countertop moulding

Does anyone know of a source where I can buy chrome edge-moulding (1 1/2" or wider). This is the moulding that was used...
5 comments posted 20yrs
posted by Totalrod2
5 comments posted 20yrs posted by Totalrod2

Query - How to roundover rounded ends?

Folks - Greetings! I haven't checked in, in quite a while - the "signal to noise" ratio gets to be a bit much, and comi...
3 comments posted 20yrs
posted by johnmoorhead
3 comments posted 20yrs posted by johnmoorhead

Anyone have a General International 15-250 Sander?

I just bought a new General International 15-250 double drum sander, to be used in finish sanding of hardwood boards. I...
0 comments posted 20yrs
posted by gus_zernial
0 comments posted 20yrs posted by gus_zernial

I not understanding this?

Could someone kindly explain to me whats meant by this below? "If you like extra work but a better finish, then rout a...
32 comments posted 20yrs
posted by allo
32 comments posted 20yrs posted by allo

Bandsaw

Anyone use this saw or a comparable product? I work at a small east coast boat yard & our band saw while great in it's...
2 comments posted 20yrs
posted by billrod
2 comments posted 20yrs posted by billrod

Re: Good news - SPAM

JOAT It's not hard, if you get your mind right. - Granny Weatherwax
0 comments posted 20yrs
posted by Jakofalltrades
0 comments posted 20yrs posted by Jakofalltrades

Dremel Scrollsaw Station Question

Does anyone use the spiral no pin blades? I can't get one to fit into my new scrollsaw properly, they don't have much o...
0 comments posted 20yrs
posted by emily345
0 comments posted 20yrs posted by emily345

<grins> for Amazon

And a good, healthy shake of the head, too. I bought a Milwaukee 5625 router and a 1/4" collet to go with the 1/2" coll...
5 comments posted 20yrs
posted by replyon
5 comments posted 20yrs posted by replyon