Workbench vises?

Guy LaRochelle · 2004-04-05T00:00:22+00:00

Hi guys,I just got done building my base for my workbench. Now I am planning for myvises. I see front vises, tail vises, veritas twin screw vises, etc outthere. I was thinking of putting a veritas twin screw vise on one end of thetable and I was going to put a front vise or something on the side of thetable at the opposite end. Would a tail vise be better than a front vise? Orhow about one of those shoulder vises? Can someone give some pointers on whyI would choose one over the other? Regards. -Guy

Apr 05, 2004 24 Replies

Rate this thread:

Swingman 22 years ago

... or Cholmondeley to an American.

Vote

mttt 22 years ago

How about 'splaining "Worcester" to me?

Vote

Swingman 22 years ago

I could ... when I figure out how Refugio comes out like it does down here in Texas.

Vote

Han 22 years ago

charlie b wrote in news:4075794E.2212 @accesscom.com:

Actually, it was a famous tree in the old Arboretum in Wageningen, when I was a kid some 55 years ago. It was spelled exactly like that on the little marker next to it. As an originally Latin-like name it was not difficult to pronounce at all (Linnaeus di much of his work at the then famous university of Harderwijk - long since gone to , not pot, but fishing).

Vote