Question: How exact does one have to be when centering the router over the router plate cut out and screwing it to the plate?
Mark
Router Plate Installation
Mar 21, 2005
3 Replies
As long as the largest bit (usually 3-1/2") won't hit the edges, you are "close enough". It does not have to be accurate to 1 gnat's ass.
Dave
Mark wrote:
If you are going to use guide bushings in the plate, you need to be right on. I saw an alignment tool some place that sets it up for you. wasn't very expensive
Rich
Unless your plate takes guide busshings.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required