"And my warped little mind ..."

pyotr filipivich · 2023-01-17T18:31:03+00:00

I have a pierce of 3/4 plywood, about 5'by2', currently the back of adesk hutch. Once upon a time, it was a headboard, but it got cut downwhen we "downsized" and 'tad-dah!" I had the back piece and the sidepiece uprights.But it was warped. In both directions.Any suggestions for "straightening a sheet of plywood?(I know, I could just find the "flattest" part and cut that out)

Jan 17, 2023 Last reply: 3 years ago 23 Replies

Rate this thread:

pyotr filipivich 3 years ago

I thought the same - don't have a bath tub.

Besides, might be simpler to just get a couple more heat lamps and dry the convex side.

Vote

pyotr filipivich 3 years ago

snipped-for-privacy@notreal.com on Thu, 19 Jan 2023 22:18:44 -0500 typed in rec.woodworking the following:

Ah, no.

Vote

Bill 3 years ago

I subscribe to the motto, "Sometimes you have to be willing to break it in order to fix it". And sometimes I break it, but fortunately most of the time I don't. : )

Vote

Leon 3 years ago

Thumbs up!

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required