Thinking of installing some TVR (Thermostatic Radiator Valve) but the they all seem to come with 15mm IN/OUT fittings. I have old radiators with what seems one inch nut connectors - though the supply pipes appear 15mm
Anyone had experience of fitting these to old radiators with large connecting nuts
Thanks
"Will" wrote in news:4e7b85e2$0$7795$c3e8da3$ snipped-for-privacy@news.astraweb.com:
The new TRVs will come with tails to suit. (15mm in/out fittings)
When you drain down to fit the TRVs remove the old tails and fit the new ones.
--- Posted via news://freenews.netfront.net/ - Complaints to snipped-for-privacy@netfront.net
Could you be more specific about these "one inch nut connectors"? Most radiators - even old ones - have female BSP threads, into which adapters ("tails") are screwed, often specifically to match the particular make of valve. A very common size for the female thread is 1/2" BSP, which, perhaps confusingly, is not 1/2" overall diameter, but around 21mm. Could this be what you have?
Threaded connectors on radiators were historically sealed with assorted gunge and hemp, and can be difficult to remove after many years undisturbed. Nowadays one would use PTFE tape or one of several proprietary thread sealants.
Thanks everyone - your advice is much appreciated
Have something to add? Share your thoughts — no account required.
Ask the community — no account required