Hi all,
In the current Screwfix catalogue they're doing a round sink + drainer + mixer tap combo (see page 195) which I'm looking at getting for our utility. To save a bit of time plumbing I thought I'd get a set of flexi-tap tails (15mm compression to mixer tap thread (pg 212)) to go with them. They do them in two sizes (M10 & M12) but does anyone know which size I'm likely to need for the aforementioned tap? Gut feeling says 10mm from the picture.
Out of interest, is there a reason for multiple sizes? I'd imagined one's for bathroom fittings, but they're both 15mm, not 15/22.
Cheers,