pipe cup reducer terminology?

Jul 21, 2008 1 Replies

Rate this thread:

R D S 18 years ago

I have lost a bit off the bottom of a machine.

It is essentially a reducer, looks like a cross between a funnel and a cup (or bowl) so that i can attach a pipe of approx 1 inch to the aperture on the bottom of a machine of approx 5 inch.

I am sure I will be able to get one from RS but struggling to think of what to search for.

Any suggestions?

Vote

Dave Plowman (News) 17 years ago

Not enough information and too vague. Does it fit into a pipe or over it? Same for the other end. What are the exact sizes? But I must say it sounds like it may only be available from the makers.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required