I am trying to join two aluminium or stainless rods together end to end. something which i can unscrew at the ends to make them shorter after use.
whats the screw called. its to make a long net and the handle needs to able to extend down a pier.
many thanks
something like a billard cue joint
========================= You need a 'sleeve nut'. An example can be seen on the end of the fitting shown here:
No need to call the OP a nut :)
NT
The message from " snipped-for-privacy@yahoo.com.sg" contains these words:
Sounds like you want a threaded sleeve welded or glued or staked or crimped or rivetted to one bit and a thread cut on the other.
Could you use drain rods? Save you having to manufacture them.
Christian.
them into a single block.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required