DIY house build

The rest of the world think's we're weird for having them in the kitchen - either a separate utility, the basement, sometimes upstairs where the laundry comes from, or in a bathroom. Washing machines generally cope with the humidity. Sometimes the socket lives outside the bathroom so you unplug it when you're not using it.

Theo

Reply to
Theo
Loading thread data ...

And everywhere except the UK which has stupid rules about electrical outlets in the bathroom.

Reply to
zall

The rules don't ban them altogether, but our bathrooms are typically so small that the rules about positioning them relative to bath, basin, shower etc has the effect of not allowing them anywhere ...

Reply to
Andy Burns

Brian Gaff snipped-for-privacy@gmail.com wrote

Can you spell that out a bit more please.

Reply to
Rod Speed

Plenty don't have a basement at all.

Reply to
zall

OTOH there are a fair few bathrooms where a w/m can be placed outside zone 2 with the flex taken to a SFCU outside the room to avoid the 3m rule. Most people just don't think of it because they are so used to seeing them only in kitchens or utility rooms.

Reply to
Robin

Of the two main limitations (other than the rooms typically being too small) - the prohibition on sockets in proximity to water etc, is not an big issue since you can hard wire them to a switched FCU. The other limitation is the suitability of the appliance for use in damp areas.

Reply to
John Rumm
<snip>> The other

On the bosch.com site they say they can be put in a bathroom, laundry room or cellar. They don't mention kitchens :)

Reply to
Robin

Yup. Check their community page on YouTube.

Food cellar on their main house has also become their air raid shelter. :(

Reply to
Adrian Caspersz

I'm not going to check it but I thought there was a drone shot just before the finale that showed the external walls all white but they were unfinished in the final closeups. An editing issue if so.

Reply to
Peter Johnson

The first use of plastic pipe I saw, in 1962, used that method. The plumber used a tool heated like an old fashioned soldering iron with a blowlamp, which fitted over teh pipe at one end and into the fitting at the other, removed after so many seconds and the pipe and fitting pushed together, never to come apart again.

Reply to
Brian D

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.