Masking tape top tip

Cost, white quid a roll, blue UV resistant 1.89 http://www.toolstation.com/shop/Adhesives+Sealants/Masking+Tape/d180/sd2728 Can`t reccomend tape n drape highly enough, disposable dust sheet on a roll, with UV resistant masking http://www.toolstation.com/shop/p49011
Posted by Adam Aglionby in UK Do-It-Yourself Forum 11 years ago 
"Genuine" lithium ion batteries?

A computer shop. A powertool shop (the one on my High St has sadly closed, but there must be one somewhere). Argos: http://www.argos.co.uk/static/Product/partNumber/3896170.htm regards, Ian SMith
Posted by Ian Smith in UK Do-It-Yourself Forum 10 years ago 
240volt vs. 120volt

120 volt light circuit maybe 14-3/G Most of us have shop circuits wired with 12-3/G and an occasional 10-3/G. 12-3/G goes most places in my shop 120 or 240. rhg J. Clarke wrote:
Posted by Robert Galloway in Woodworking Forum 22 years ago 
BUFF has arrived

Oh, and cleaning the shop is the downside of new 'capital' tools. One upside is a temporarily clean shop. Ice and Advil, friend. Patriarch
Posted by patriarch in Woodworking Forum 21 years ago 
Heating garage workshop

100,000 BTU in a 24 x 32 shop??? Put some insulation in that sucker! My shop is 24 x 38 feet and I heat it with a 50,000 BTU furnace, which is still a bit large. North Dakota winters! Greg
Posted by Greg O in Woodworking Forum 21 years ago 
Good place to buy cabinet doors?

.;-) Well, as I see it then, between your father's woodworking shop and your machine shop - you can make everything, including the hardware. So why wimp out on this challenge...;-) Bob S.
Posted by BobS in Woodworking Forum 20 years ago 
Gloating? you bet

Hey, my wife demanded I expand my shop and then told me to go ahead and buy the drum sander I wanted. Of course, in my case she just wants me to spend more time in my shop. How about you?
Posted by Toller in Woodworking Forum 20 years ago 
Dust Collecting: Filter or Not?

If you have a fuel burning appliance (gas water ehater, dryer, furnace, etc) sharing space with the shop it is possible to create a backdraft in it's flue leading to combustion gas coming iside the shop rather than out the chimney.
Posted by Lawrence Wasserman in Woodworking Forum 20 years ago 
Fire/smooke detection in the shop

Mount a smoke detector just outside the shop door and connected with the others in the house. Vacuum it off once a month. No compressed air. Keep the shop door closed whenever possible. I dont know about heat detectors. Tom
Posted by Tom Woodman in Woodworking Forum 20 years ago 
Moving

They are pros and know how to crate/box/move your shop. I moved my shop 400 miles with no problems. They even tossed all my lumber on the van and strapped it down. Bob
Posted by bob in Woodworking Forum 20 years ago