Handleset and door thickness

[bobnew...]

My wife wants to replace our existing door hardware and I tracked down the parts to these:

85350.056.RENT 85350.056.LFD

These specify 1.75" door thickness, I have 1 5/8. Can I use these? Any special installation tricks?

[rbowman]

That site gives a little more latitude for the door thickness. The Baldwin site mentions adapters for thicker doors,

According to the first site your wife has some expensive tastes...

[gfretwell]

We seem to have more fractional confusion here 1 5/8" is 1.625" Thinner than the max 1.75. To the op they are referring to max thickness and your door will be fine.

[bobnew...]

[e-mail]: Thank you very much for your post. I was hoping this was the case but wanted confirmation before spending $760 on hardware for the two doors. And to rbowman, who observed that my wife has expensive tastes, yes this is often true. Fortunately, I was able to find these handlesets for $400 for the 5-pin cylinder and $360 for the dummy, rather than $525.70 as listed in your link. Still high but not quite as expensive as you found.