Gas Logs remote doesn't work

Jan 08, 2009 6 Replies
B

-------------------------------------



We have a ventless gas log set. It is turned on and off with the remote. About a month ago the remote stopped working. We have reset it, changed both the batteries in the remote and the base and still no luck. We were told to blow out the sensor. Does anyone know anything about this. We now have to turn it on with the base. Thaks


##-----------------------------------------------## Delivered via

formatting link
Construction and Maintenance Forum Web and RSS access to your favorite newsgroup - alt.home.repair - 333802 messages and counting! ##-----------------------------------------------##


Vote
Twitter Facebook LinkedIn
V

Hope you have a C0 detector.

Vote
Twitter Facebook LinkedIn
V

Especially if one is 'unvented'.

Vote
Twitter Facebook LinkedIn
A

Also make sure the battery contacts aren't corroded. Finally before giving up on the remote, the circuit board is probably very simple. Mine was and had a bad solder in the receiver. I took the case off and pressed around while working the remote and found the bad solder. Resoldered it and fixed it. That was 5 years ago and its still working.

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required