Model SHU9955 - due to the accidental application of excess weight to our dishwasher door when it was fully open, I believe the hinges are now slightly pranged to the point where the door will no longer remain latched closed.
I attempted to remove the hinges but after getting the lower panel off and poking around in there, I was unable to locate the cable and spring which was described in an email to me from Repair Clinic.com. Also, I believe the hinges are in fact mounted by a single screw which is attached from the outside of the unit, and this area is covered by a sheet of metal cabinet material, so I am now of the belief that on this model it will be required to fully remove it from the counter and then probably tip it over on the backside in order to access the spring and cable.
Is that correct or is it actually possible to replace hinges in situ?