AC/HEating Questions

Jul 02, 2006 6 Replies
M

Hi, I own a brick end of group 1,148 sq ft house w/ metal replacement windows. It's got baseboard electric w/ a thermostat in each room. I use low energy bulbs. My utility bill G&E is $89.00 a month. Only gas appliances - water heater & stove (I don't use the dishwasher) Electric rates were regulated @ 4.7 cents kwh July 1st electricity was deregulated.12 cents kwh and each year I'm sure it'll go up as the ten most highest price markets are all deregulated. Besides, it appears, deregulation is costing consumers more money each month, should I install central air/heating system or stick with my high efficiencies GE windows airconditioners and electric portable heater I bought from COSTCO. Is there a heating newsgroup I should post this to?



Thanks in advance,



Mike


Vote
Twitter Facebook LinkedIn
M

I live in the midatlantic region, near DC, w/ hot humid summers and cold winters.

Vote
Twitter Facebook LinkedIn
M

Mike if I were you I would do this-insulate first- then put in a high efficiency heat pump and gas furnace- then you have best of both worlds. Your heat pump will take a majority of the heating load and your gas furnace will take up the slack when it gets too cold. Insulate , insulate, insulate- your quickest payback!

Vote
Twitter Facebook LinkedIn
J

Resistance electric heat (baseboard) is inexpensive to install, comfortable and likely the most expensive option possible in the long run.

What other sources of energy do you have (gas oil etc.)?

If only electric look for a whole house central heat pump - AC unit. Get some estimates. Also have you home checked for insulation and energy efficient windows.

Vote
Twitter Facebook LinkedIn
M

no duct work and no radiators are in the house, so I'd have to have duct work installed. Will try to find a local expert to check out mt house.

Mike

>
Vote
Twitter Facebook LinkedIn
M

Thanks Mark, I'll try to find an expert in my area to come by and recommend a system Recently, I read an article that described how important correctly installing ductwork.

Mike

Vote
Twitter Facebook LinkedIn
F

I wouls ask Fat Eddy at,

formatting link

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required