I got desperate for a scraper today, so grabbed one of my putty knives (Now dammit; no laughing!!!!) and proceeded to flatten the edge on a diamond sharpener. Ran a screwdriver shank over it about half a dozen times, and damn if I couldn't feel a sharp edge! Ran over to the glue-up drawer front (yesterday's screw-up, which I salvaged) and scraped a bit of protruding edge to flush the two pieces up. Damn if that wasn't almost mystical! You Neanders JUST might have something there. The grain was just POPPING out at me!
I guess I could skip the $18 burnishing tool when I get a set or "real" scrapers? BTW what's the difference between a scraper that is labeled a scraper and a scraper that I "made"?
- Better cachet
- Edge will last longer
- Both one and two
- None of the above
dave