Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

STEERING WHEEL AND PEDALS

http://www.student.oulu.fi/~heinanen/wheel.htmlJOATMy son is an HONOR TEENAGER at the county jail. - Seen on a bumpr sti...
0 comments posted 21yrs
posted by Jakofalltrades
0 comments posted 21yrs posted by Jakofalltrades

GROTTO-STYLE CAGE

http://www.dapper.com.au/cagebuild.htm About the only so-called pet that makes less sense to have then a rat would prob...
0 comments posted 21yrs
posted by Jakofalltrades
0 comments posted 21yrs posted by Jakofalltrades

FOOSBALL TABLE

http://www.foosball.com/tablebuildingguide.html Personally, I can think of many, many, more interesting ways of wasting...
0 comments posted 21yrs
posted by Jakofalltrades
0 comments posted 21yrs posted by Jakofalltrades

Cost of Heating oil; Cost of lumber?

Just asking: If the cost of Heating this winter goes up like the cost of Gas, Should we be worried about cost of lumber...
84 comments posted 21yrs
posted by no spam phil
84 comments posted 21yrs posted by no spam phil

OT - SCALE MODELS OF JPL SPACECRAFT

http://www.jpl.nasa.gov/scalemodels/ Actually, it's only sorta OT - does use cardboard/cardstock. Be kinda neat to give...
0 comments posted 21yrs
posted by Jakofalltrades
0 comments posted 21yrs posted by Jakofalltrades

Tearout using planer on birch

I'm seeing tearout using a planer on birch. a closer look at the grain of the board I'm planing shows the grain in a u...
5 comments posted 21yrs
posted by mark.young
5 comments posted 21yrs posted by mark.young

Laser guides for drill presses

I noticed that some drill presses come equipped with laser guides. Is this something that you can buy as an attachment t...
20 comments posted 21yrs
posted by "mywebaccts (at) PLUGcomcast.n
20 comments posted 21yrs posted by "mywebaccts (at) PLUGcomcast.n

1/16" raw veneer source???

Searching for supplier source for 1/16" raw ash veneer, not backed veneer. Anyone have any good sources to suggest. Than...
1 comments posted 21yrs
posted by vflores
1 comments posted 21yrs posted by vflores

How to stain/dye/enhance figured Maple

I usually leave Maple alone and just produce white pieces with clear lac or slightly yellowed with NC lac. However, in...
7 comments posted 21yrs
posted by bwx200
7 comments posted 21yrs posted by bwx200

TS as Disk Sander

Have old Montgomery Wards (PowerKraft) 10" TS and a metal sanding disk to fit it. Replaced the saw with a Powermatic 66...
6 comments posted 21yrs
posted by nevems2
6 comments posted 21yrs posted by nevems2

Finishing

A friend of mine has a table he wants to finish, in semi gloss polyurethane. He has about 3/4 gallons ea. of satin and...
8 comments posted 21yrs
posted by lindquist
8 comments posted 21yrs posted by lindquist

Two-Part Epoxy?

Anyone have any experience using two-part epoxy on painted metal? I need to "pull" some painted metal similar to automo...
29 comments posted 21yrs
posted by bob
29 comments posted 21yrs posted by bob