Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

Interesting way to build an expanding table.

Check out the videos here http://www.dbfletcher.com/capstan/. I'm sure the magic is all in the mechanism, not the woodw...
9 comments posted 19yrs
posted by roy
9 comments posted 19yrs posted by roy

That time again.... almost OT

G'day boys and girls It has been a long time since I last had the time to wander through the "wreck" Good to see that i...
7 comments posted 19yrs
posted by nangal
7 comments posted 19yrs posted by nangal

Rough Cutting for project

Hiya Folks, I'm about to start a new project that requires a number of spindles. These spindles should be 7/8" diameter...
2 comments posted 19yrs
posted by Nospam
2 comments posted 19yrs posted by Nospam

Amazing expanding circular table

Check out these tables, amazing. "It is a circular table which, when rotated at its outer perimeter, doubles its seatin...
14 comments posted 19yrs
posted by dpenney
14 comments posted 19yrs posted by dpenney

INSPIRATION - Toad Stool

http://www.creationsbykim.com/Images/LevelsNEW/toad-stool.jpgJOATI am, therefore I think.
0 comments posted 19yrs
posted by Jakofalltrades
0 comments posted 19yrs posted by Jakofalltrades

DeWalt 710 RAS fixer upper question

Recently picked up an old radial arm saw and need a bit of advice Manual available here http://www.owwm.com/files/PDF/D...
2 comments posted 19yrs
posted by magneto
2 comments posted 19yrs posted by magneto

Tablesaw blade trunnion adjustment question

Excuse me if this is a repost of my request. I tried to post it previously and it did not show up in my sent folder, so...
15 comments posted 19yrs
posted by tom
15 comments posted 19yrs posted by tom

Tablesaw blade/trunnion adjustment question

I have a Grizzly G0444Z TS. The back of my blade when I rip a board is almost a quarter of an inch closer to the fence...
15 comments posted 19yrs
posted by tom
15 comments posted 19yrs posted by tom

Old house, x-large register vents...

So I am rehabbing this house (built approx 1930), doing the finishing trim now. I go to put the store bought register v...
6 comments posted 19yrs
posted by locutus_atai
6 comments posted 19yrs posted by locutus_atai

wheels on stand

I have a metal work stand, 18" x 20". I want to put my chop saw on it. Can someone suggest how to put caster wheels on i...
4 comments posted 19yrs
posted by pattj
4 comments posted 19yrs posted by pattj

Craftsman Radial Arm Saw

Does anyone know where I can get the router and drill attachment for my old Craftsman 10 Inch Accra-Arm Radial Saw?
7 comments posted 19yrs
posted by villafum
7 comments posted 19yrs posted by villafum