I am trying to make a saw. I need to find a mandrel (Shaft, pillow blocks, pulley) that has a 1" threaded shaft. Does anyone have a source for something like this?
Thanks
Dan Burkhardt Signs of Wood, Co.
formatting link
Looking for Mandrel
May 28, 2004
3 Replies
and I'd be astonished if McMaster-Carr doesn't, too.
formatting link
might also try
formatting link
On Thu, 27 May 2004 18:36:06 -0700, "Dan Burkhardt" stated wide-eyed, with arms akimbo:
Try
formatting link
or
formatting link
, Dan.
- Yea, though I walk through the valley of Minwax, I shall stain no Cherry.
formatting link
Like this?
formatting link
was also a fine cast iron bodied one at
formatting link
as a close-out or maybe it was at
formatting link
I guess not because this is all I found there:
formatting link
then I found it here from a search:
formatting link
the same became cheaper on this page, I think it is a closeout:
formatting link
I found it IS a closeout on this page:
formatting link
Grizzly has another kind with a 5/8" shaft here:
formatting link
formatting link
has them here too:
formatting link
I have the same interest I did the searching and it's all I could find, but I think you should get one of these and search high and low for that threaded 1" adapter at the other sites posted for you. It looks like these mandrels need to be mounted up higher as shown in the Lee Valley page.
Alex
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required