Finishing problem

Hi, I am finishing an oak coffee table with Watco. It is solid oak. The top is laminated panels. I scraped and sanded it but it seems I missed a little glue on one joint. The oil won't penetrate this area and it is quite a bit lighter than the rest of the top. Is there a way to repair this? Can I sand it down again and re-apply some more oil and if so will it blend in well? Thanks for any advice you can pass along.

Reply to
BeerBoy
Loading thread data ...

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.