Delta Table Saw 36-320c 10 Inch Problem
Sep 15, 2006
22 Replies
replying to brucebrown100, Dodge Man wrote: Hello Bruce I have a 36-320C it has a belt ,if you take the plastic end off the motor you will see a belt it is small but it is there . once you remove the protector cover you need to remove the screw and washer then you can slide the belt of the spline's replace in reverse be careful while sliding the new belt back on that you don't damage it. hope this was helpful. Cheers, Wayne
replying to brucebrown100, Ryan Petis wrote: Hey Bruce, the belt is probably shot which is housed inside the motor itself... here's a good site that actually sells this belt
formatting link
copy that url and paste into your search engine, hope this helps
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required