Why do circuit breakers go up for on and down for off?

Not feasible to do it on a naval vessel given that the cannon is rolled out with the nozzle outside the ship before it is fired on a naval vessel.

The navy went for the other alternative, keel hauling which mostly killed the keel hauled.

Steam locos certainly did have springs. The axles passed through bearings that were guided in hornblocks fixed to the locomotive frames. In some cases the springs were a leaf spring and in others, pairs of coil springs.

They might be visible from the outside:

Not just bulbs. All electrical appliances. While at university, I had a coffee machine and a soldering iron which had 200v elements. Households would obviously had many more items.

When the deer jumps out of the hedge in front of you and stays mesmerised and stationary in the headlights?

Completely impractical if the danger is hidden until you get there. Children and animals dashing across the road. wheel smashing potholes full of water that the council can't afford to fix because they spent the budget on speed cameras sleeping policemen and totally unnecessary traffic lights. Old truck brake drums dropped from pedestrian bridges by bored teenagers.

The list of 'stuff that you can hit that wasn't there last time you looked' is endless.

Maintaining idealised safe distances is an idea only people who don't really do much driving believe in.

Pointless as modern power supplies can easily accommodate wide ranges of voltage. They should have left it up to manufacturers to decide what range of voltage to cope with, depending on where they wanted to sell the goods. 100-250V (50/60Hz) for Europe and US, 200-250V for UK and Europe, 220-250V for UK only. Some goods are/were only suitable for the UK due to language and TV system.

Euroharmonising for the sake of it.

? I think there were springs on the driving wheels actually. Really big locos were more the province of the USA with its enormously long straight tracks

In practice the railroads were built to run steam trains with up to 8 close spaced driving wheels, and if that made life difficult, tough.

The big 8 wheelers were more suited to the USA with bigger steeper inclines but seldom tight curves.

Also for use in more cramped conditions twin sets of drive wheels and cylinders could be used.

Curiously, others than yourself thought about this at the time

How do you know it wasn't accommodated within the acceptable tolerance for mains voltage? 230 is just "nominal".

Same here. The stated voltage just changed.

Yes, it has been my experience that the Spanish even in S America prefer to build with concrete or blocks as the high thermal mass is useful in reducing peak temperatures by day.

Whereas the USA is the home of the timber frame as long as its got air con :-)

It is quite hard in the UK to get a mortgage on a 100% timber frame.

Yup. I built several of those on 27Mhz for model planes. Not with valves though.

Old mains radios had a switch at the back to set the voltage. Easier with AC than DC as it just switched the tap on the mains transformer. For DC there was a dropper resistor. If it had to work on 120V AC/DC the set was designed for the lower voltage and had to dissipate the extra power in a resistor, often built into the mains lead.

Ok, I see them. I will have to look more carefully at others.

Just barely for the old bulbs. 230 would be OK, but the new margins meant the voltage could go to 240, and that was not OK for appliances. Slowly, eventually, we had to replace everything. But not possible to claim that they failed sooner for overvoltage.

Not for the sake of it.

I have been able to buy UK appliances via Amazon to use here, knowing that they would work fine.

In that case, I won't be able to hit the blinkers, either.

Tell that to the regulators.

Cartagena.

Nope.

If manufacturers want to cope with different voltages and frequencies they can. Or not, if they dont.

I am fairly sure that one of my guitar amplifiers has an SMPSU that can cope from 110V AC or DC to 240VAC or DC.

I haven't read the replies.... So you can't turn them on by accident?

We never lost them. In most places, the usual voltage is still around