what is the trick, when you fit taps, that prevents the tap body turning.
If I overtighten, the stupid plastic nuts strip the thread.
Thanks Rick
taps
Aug 31, 2005
2 Replies
The trick is to hold the nut and swing the tap into position, you might have to attempt it on2/3 goes till its tight and in alignment with tother tap.
Avoid taps with plastic nuts! Also, a little silicone under the tap helps to stop it turning.
Dave
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required