Oil for hair clippers

The oil for my clippers has just run out (literally - seems that the bottle is about as oil-tight as a Royal Enfield or Sunbeam S7/8!). Went to Boots, only Philips spray stuff/cleanser at £silly. I hope that the oil isn't just light mineral oil - not the sort of stuff I want on such implements.

Is there a 'special' oil and a source? Can't seem to find anything useful.

Reply to
PeterC
Loading thread data ...

formatting link
formatting link

Reply to
Richard

Baby oil would probably do and it would be safe for skin contact - it is just a mid mineral oil.

Reply to
Tim Watts

If it were me, I'd just walk half a mile to the Wahl UK warehouse!

Seriously....I'd try a specialist razor shop. They have that sort of stuff too.

Reply to
Bob Eager

Do you mind?!! I loved my S8. (reg 9680 H)

Reply to
Bob Martin

Thanks. From the feel of the original droplets supplied, I thought it might just be a rip-off and was plain oil. Vegetable oil would be OK if it didn't set. I did wonder about biodegradable chainsaw oil, but the quantity would be ridiculous and the clippers might get ideas!

Reply to
PeterC

Good idea that man! I wonder how the manufacturers get the babies for squeezing for oil (same for baby powder).

Reply to
PeterC

My S8 was overhauled by the factory in Putney in about '67 but still leaked

- I drilled a small hole in the bottom of the distributor so that the points weren't submerged. Mate's S7 always leaked. Going on tour was a treasure hunt for straight 50. The only oil-tight one I ever saw belonged to the lass who ran the factory.

Reply to
PeterC

Bob Martin scribbled

A boy at school had one with a single plank sidecar lashed on the side to get around the 250cc learner limit. Bike cost him about £30, would be worth a small fortune now.

Reply to
Jonno

Not quite hair clippers but a while back I had a beard trimmer. Not sure if hair clippers work in the same way but basically these were miniature hedge trimmers - two toothed plates rubbing against one another. And yes its a clich? but the odd drop of WD40 now and again worked wonders. My beard never fell out anyway and I doubt it would do that much harm to hair either. But there again, someone just posted about their binoculars smelling bad. I thought the story would be that they'd dropped them into a septic tank or something. But no just an oily smell. So what do I know ?

michael adams

...

Reply to
michael adams

+1
Reply to
newshound

An update: on an impulse I bought a bottle of Johnson's Baby Oil and it seems to work. Tried it on the cheap trimmer and the speed increased noticeably. Now to see how long it lasts.

Reply to
PeterC

just use 3in1

Reply to
rick

----------------------------------------------------------- i understood whale oil is the best since they use it on ballistic missile gyros. a runner up is: walnut oil (available from waitrose ) that wood workers use as a non-rancid-turning oil. Or so i've heard.

Reply to
john west

----------------------------------------------------------------------- i understood whale oil is the best since they use it on ballistic missile gyros. a runner up is: walnut oil (available from waitrose ) that wood workers use as *a non-rancid-turning* oil. Or so i've heard.

Reply to
john west

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.