In message , Mark writes
Unscrew the grub screw so that the knob doesn't actually turn the shaft
In message , Mark writes
Unscrew the grub screw so that the knob doesn't actually turn the shaft
In message , Tim S writes
Interfering fingers ?
In article , Dave Starling writes
Installer menu - Category 1 - Parameter - Temperature Offset (12:tO) - set to +1.5 will fix that ;-)
Way back when in rented accommodation with a load of other young blokes we had the opposite problem,the landlady kept herself warm in her self contained flat upstairs but the Telly lounge/common room was decidedly chilly. Then one lad found that his workplace held cans of freezer spray in its stores. A good blast over the thermostat sensor every so often kept the heating on nicely. Nice low tech solution that avoided any tampering.
G.Harman
Have something to add? Share your thoughts — no account required.
Ask the community — no account required