Ethernet Conduit

RJH · 2013-04-28T07:57:14+00:00

Just at the point before plastering, so I intend to build in the option to hard wire internet and network connections by installing trunking/conduit from the top of the house (2nd floor) to the bottom (cellar) in one vertical run. I intend to cut a channel into the existing plaster and fit the conduit. The plasterer can then make good - the whole house is getting a skim. It's going to be easiest to keep all the gubbins (NAS and switch) in the cellar, which would require the capacity for 6 Ethernet cables. I'm using homeplugs at the moment which are fine - I'm after better performance. What's the best sort to use (round/rectangle section?) and what's the minimum diameter/area I'd need? A link to something would be handy - from say: Thanks, Rob