Does exist a 15mm pre-bent copper pipe section with tight (approx 15mm radius) bend

can you not presolder an end feed elbow with a couple of bits of pipe in, that would scarcely be fatter than 15mm tube

mrcheerful

In article , Peter writes

Sorry, I can't picture the problem, can't think of anything more compact that using 2 pieces of pipe with a soldered knuckle bend. You may get what you want by butchering a part crossover: BES code 9202

Does that help?

| I am looking for something for a tight corner pre-bent 15mm copper | pipe section, something like a street bend, but with both ends male | and with longer legs. i.e. just a tightly bent tube using a bend | radius of about 15mm. Does such an item exist? I don't quite have the | space in this installation to use separate elbow pieces.

You can get 12 inch lengths of corrugated 15mm pipe which can be bent round very tight corners, at most DIY places.