I have an old Wickes 40 balanced flu boiler in a 60's semi rads are connected via microbore New Pump, Cylinder, valve and C27 controller
The problem is (CH on only not HW) the boiler can be heard boiling then cuts, and within a minute starts boiling (kettling?) again and this just goes on and on. The know on the boiler is turned to MAX The house sits around 18 degrees not getting anywhere close to the stat on the wall, and the cupboard where the boiler and cylinder sit is roasting hot
Any ideas? could the pump/valvue be wired incorrectly or something? Fingers crossed its not new boiler time?
Thanks in advance