Boiler and Thermostat Setup

Jan 08, 2007 1 Replies

Rate this thread:

yshaikh01 19 years ago

I have a Heatline S30 Compact Boiler and I just wanted to make sure I was setting things up correctly

The CH Temp control on the Boiler has an "e" mark (for highest effiecency according to the manual). If the boiler is set to this, which is quite high. I think it heats to about 70C if i remeber correctly.

The Prog Room Stat should then be set to desired temps and times.

Is this the best setup? or should I leave the Boiler on low?

Thanks

Vote

Ed Sirett 19 years ago

Set the boiler to the lowest setting that allows the radiators to heat the house. If the boiler also heat the water with a cylinder then you will need to set the boiler high enough to make that happen in a timely manner. That means about 65-75C, i.e. about 10C more than the cylinder is set to. HTH

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required