Best Rated threads in Hand and Power Toolsshow all threads
| Subject | Author | Posted | Replies | |
|---|---|---|---|---|
|
|
Need opinion on Delta Air Compressor model 66-240 and Air-Tools
I bought a Delta Machines ( Air Compressor Model 66-240 Here are the specs from the manual Model: 66-240 HorsePower: 2.5 Max, 2.0 Operating Voltage/Herz/Phase: 115V / 60Hz / 1 Min Branch Circuit: 15...
—
|
19 years ago
|
— | |
|
|
Drill & tap compressor tank?
I've got an old 20 gal (?) compressor tank in which I want to install a drain. I'm guessing it to be 1/4-inch (6.3 mm?) thick steel. Tank is rated to 125 psi. Can I drill and tap this for 1/4 or...
16
|
18 years ago
|
16 | |
|
|
Craftsman Roll Away Chest Stuck Locked
I bought a craftsman toolchest last night and when I got it home I opened the drawers and then closed them and locked the chest. Now I cannot unlock the chest. I have the key that came with the chest,...
7
|
15 years ago
|
7 | |
|
|
teflon tape on air hose fitting?
I have a Senco SLS15 stapler and my question is should I use teflon tape when I screw the air hose fitting into the bottom of the stapler? It does not say in the instruction manual. Thanks.
3
|
20 years ago
|
3 | |
|
|
Air Compressor Doesn't Keep Up
6 hp 33 gallon Craftsman Oil Free Air Compressor 240V. I got this unit used, was previously used for spray paint duty by a homeowner, so it did not get much service. Looks new, actually. It takes...
7
|
17 years ago
|
7 | |
|
|
Refurbishing a sabre-lath
I've been working on improving the condition of my Shopmate Sabre-lathe 2610T0. I finally figured out how to get the case go back together (there's a notch in the bearings on the spindle that must...
2
|
17 years ago
|
2 | |
|
|
Milwaukee 18V charger PCB schematic
I am looking for the schematic for the Milwaukee 18V charger # 48-59-0240. Does anyone know where I might find a copy of this diagram? Thanks.
2
|
18 years ago
|
2 | |
|
|
Fre Flo Eqpt Model 2103 air compressor
Does anyone have a manual or information on this painting compressor? I don't know how old it is. I inherited one with a manufacturer's number 029. It's electrically powered and the compressor works....
—
|
17 years ago
|
— | |
|
|
Black & Decker miter saw parts help needed
Greetings group. I have a B&D 9425 miter saw and the on/off switch has gone bad and B&D no longer supplies the switch. I would hate to toss an otherwise good working tool which is what they suggested....
5
|
19 years ago
|
5 | |
|
|
Craftsman Planer/Molder
I have a Craftsman 12-1/2" Planer/Molder, model 351.233831. Recently I went to change the planer blades and cannot get the blades or the gibs out of the cutter head. Unfortunately, during my last move...
2
|
20 years ago
|
2 |