this belt its purpose is to drive the tractor .it runs from the top pulley to engine pulley shaft .oddly enough it the original belt on 11 hp. 36 in cut
- posted
11 years ago
this belt its purpose is to drive the tractor .it runs from the top pulley to engine pulley shaft .oddly enough it the original belt on 11 hp. 36 in cut
Is this the Sears part number #
917254220 ?  From the Owner's Manual: <strong>Motion Drive Belt Replacement</strong>The tractor drive belt may be replaced without tools. Park the tractor on level area, Engage parking brake. NOTE: BELT INSTALLATION DECAL UNDER LEFT FOOTREST. a. Remove mower. (See mower section, page 22). b. Remove two retainer springs from belt guide bracket below transaxle pulley. Remove bracket (Fig. 26). c. Swing belt guides away from belt, toward rear of tractor (Fig. 26). d. Roll belt over top of transaxle pulley. e, Roll beit over engine pul/ey and off idler (Fig. 28). f . Release parking brake. Pull belt as far as possible over top of clutch pulley. g. Reset parking brake. Pull belt over top of clutch pulley (Fig. 28). h. Pull belt out through shift gate to remove from tractor (Fig. 27).
Install belt by reversing above procedure. NOTE: REPLACE ONLY WITH BELT LISTED IN MANUAL.
Here's the manual:
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.