That's why I don't fly in these knock-offs of a 110 year old design by two guys who worked in a bicycle shop.
I built one in high school shop (using a kit) but it never looked that good. My mom still has it 60 years later.
What's the optimum angle for sharpening a shop knife? I've seen 22 degrees, but I wanted to check for other opinions.
Perhaps the guy writing up the catalog descriptions for the non-metallic "wire" got canned and landed at a bearing shop.
- Remove and take to nearest machine shop who will roll them out for minimal charge - We unhook and tow ours ashore each fall
Then shop for instalers and equipment.
Was in one of these guys places earlier http://www.floors2go.co.uk/products/tiles.html it looked good in the shop, unlike most of the plastic wood stuff.
Yes, this does beg the question if the shop was being re-laid out why wasn't it planned properly so there wouldn't be this conflict?
Ask the shop if you can have one on a sale or return basis...
Nope - ask those who cut shop front signs. The bandsaw is fine for the backing panel but for the letters a jigsaw is normally used.