Why Thin Pins

Thin pins = more pins = more prime glue surface
Posted by RBK in Woodworking Forum 22 years ago 
Lidl Parkside accessories - bank transfer only?

Tried it with the site white listed and also tried using Firefox instead of chrome. Site says Payment "For orders placed via the accessory shop at www.kompernass.com we accept payment in advance, via PayPal or credit card."
Posted by David in UK Do-It-Yourself Forum 8 years ago 
Turn heat down in shop ?

I just intalled a radiant ceiling heat in my 24X40 shop. It is a 60,000 BTU unit 20 feet long. Now, I have a question for some anal heat conservative individuals . What will be the most economical way of regulating the heat in this shop ? It is well insulated and has 12 ft ceilings.
Posted by Hilltop Cycle ATV in Home Repair 20 years ago 
Wood floor in the shop

A question; would ¾" OSB stand up to foot traffic? Thinking of 16" (both directions) OC PT 2X4 sleepers, with gaps for air and electric lines. Most likely sheets cut in half for removal, if needed. First layer of finish is thinned for better penetration, then another coat, or 3. Haven't ...
Posted by Rick Samuel in Woodworking Forum 17 years ago 
Re: Starting a new Shop?

Lets see, 6 commercial grade power tools for less than $1,600 each. Assuming you can fully depreciate in 24 months max, sounds like an opportunity. For the hobbist, may be a bit much. Lew

Posted by Lew Hodgett in Woodworking Forum 17 years ago 
Shop shoes for sore feet?

Hi Folks, My workshop/garage has a cement floor. After two hours or so using running shoes my feet start to ache, despite orthotics. (Approaching 70 does not help, I suppose). Any recomendations for suitable footwear? Thanks, Gary

Posted by G Mulcaster in Woodworking Forum 17 years ago 
Shop Solution For Home Gyms

So I went to the old shop solution and started to install casters on the side or bottom of some pieces. That way they can be wheeled into position to be used and wheeled out of the way when done. Most of the time I make an angled block so the caster is just a fraction of an inch off the ...
Posted by Lee Michaels in Woodworking Forum 16 years ago 
Shop space available: Oakley, California

The shop is intended for artisans, hobbyists or finish carpenter/ tradesmen. The shop is best equipped for furniture making but you could do cabinets, small fine work, etc.
Posted by SonomaProducts.com in Woodworking Forum 14 years ago 
Finishing the new shop floor

Based on previous comments I will be installing Advantech on 2X4 PT sleepers over concrete tomorrow. I expect it to take 2 or 3 days for 2 71 year olds to do. Once installed I want to put on 2 coats of polyurethane. I have always lightly sanded between poly coats and expect to do so on the ...
Posted by swalker in Woodworking Forum 10 years ago 
Blue Shop Towels Cause Rusting?

Doing a little maintenance around the shop, decided to change the jointer b lades. 6 to 8 months ago, I had 2 sets of blades sharpened and rolled the m in the blue shop towels, for storage. I discovered all the blades have developed rust spots.
Posted by Sonny in Woodworking Forum 9 years ago