6 discussions on HomeOwnersHub about the Grizzly G0478: what owners asked, what went wrong, and what fixed it.
Greetings,I'm considering upgrading from my current contractor saw to a hybrid saw.I'm hope to gain improved dust collection because of the enclosed cabinetand a smaller footprint than my current saw (a craftsman 10inchcontractor). I'm...
With everything it's a little over a Grand. I've looked at the Jet. General and Powermatic (along with Rigid & Delta) There wasn't a woodshop for a hundred miles that would recommend the later 2. I just can't find anything wrong with the...
I am considering purchasing either the Ryobi BT3100 or the DeltaShopmaster TS300. Any advice would be greatly appreciated. Both ofthese are 15 A machines and I am assuming that they will therefore befine on a dedicated 15A line.
I am looking at upgrading my small contractors saw to a Hybrid. Theones I am looking at are the Craftsman, The new Delta 36-717 Hybrid,the Delwalt and then I found that Grizzly has a new Hybrid, the G0478.Can anyone tell me about this saw?...
Does anyone have anything to say about the new 2hp hybrid table sawfrom Grizzly? (G0478 2 HP Hybrid Cabinet Saw) It appears to betheir contractor saw motor, inside a version of the G1023 cabinet. Itseems like a good thing for me, since...
I think this is a fairly new saw, so I'm interested if anyone haspurchased or used it.I am trying to decide on a table saw to buy and have narrowed down mychoices between the Griz G0478 and the Craftsman 22124.The Griz is approximately $250...