Refrigerator LED lights all flickering (even in the freezer)

Nov 20, 2024 Last reply: 1 year ago 9 Replies

What could it be when the Whirlpool WRS325FDAM04 has every LED light in the refrigerator/freezer flickering? Ever seen that before?


Is the flickering vibration related?

Do the lights flicker when the compressor is running?

When the compressor is off?

None of that. The lights flicker all the time. No matter what. I'm wondering if there is some kind of "led control module"?

Maybe reboot the refrigerator by unplugging power for 30 seconds or so.

OR

Loose connection? Wherever a wiring harness plugs into a component, there's a chance for loose connection.

Parts diagrams:

formatting link

LED Light assembly

formatting link

Thanks. I've rebooted the refrigerator a thousand times since it started flickering and I've taken out & put back the modules once also.

I googled a bit more and found it's an extremely common problem.

formatting link
Apparently there are three light modules in the Whirlpool WRS325FDAM04.

  1. The main front top LED control module plus a light W10515058
  2. There's also an LED light near the bottom back of the frig W10515057
  3. And another LED light in the middle back of the freezer W10515057
    formatting link
    This is perhaps the best thread on the topic (6 pages long!).
    formatting link
    By all accounts Whirlpool has no idea how to design LED boards. They all go "beserk" and start flashing within a couple of years.
    formatting link
    The design is so bad people recommend going for the aftermarket redesign.
    formatting link

Quality will improve after all the old boomers retire. They have a lot of stupid ways.

W Sun, 24 Nov 2024 22:29:53 -0500, Josh napisal:

I think this is what the OP needs as I had the same issue.

formatting link
They're wired in series so if one is bad, it will destroy the other. Most people say R15 or C4 (electrolytic) go bad but you never know.

There's no way to test it so you don't repair it. You replace it.

Yah, the refrigerator manufacturer's design is overly complex. They replaced a simple system of standard inexpensive candelabra base LED bulbs with expensive proprietary light modules. WTF were they thinking?

I think I'd rip that garbage out and install some 12v LED peel-n-stick ribbon lighting.

formatting link
Good grief!

They were thinking they wanted to be able to label it as using less electricity.

For the 5 to 8 minutes aday that the door is open - sure.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required